At the  moment I'm heaitng the  bedroom with a   little   main electricity fan  blower.
30  bucks to buy  300 bucks a year  to run.   Occhhhhh.
No   gas  fitter  will   install a   gas  heater in a  bedroom. Too dangerous.
My  proposal is a  wind generator  directly  coupled  to one of  those   oil   filled  coloumn   heaters.   
Skip  the batteries and  inverters.  Too expensive.   The wind doesn't  blow  and the heater  doesn't  heat.   No  problem here as  the only  time  the wind doens't  blow  is the summer.
The  problem is that these  comoumn heaters   run off the mains  at  240  volts while  most  domestic  wind generators   run at  12 volts.
Can anybody  point me at a soloution.??
			
			
									
									
						240volt wind generator or 12 volt coloumn oil heater
- 
				sparticuss
- margo - newbie 
- Posts: 22
- Joined: Wed Dec 14, 2005 1:56 am
- Muddypause
- A selfsufficientish Regular 
- Posts: 1905
- Joined: Mon Apr 11, 2005 4:45 pm
- Location: Urban Berkshire, UK (one day I'll find the escape route)
I think you might have your work cut out trying to make a 240v heating element do much with only 12v trying to push through it - I think the resistance will simply be too great.
Is it possible to get the element out and replace it with something that might work - a 12v travel kettle type thing that works from a car's electrics, f'rinstance?
			
			
									
									Is it possible to get the element out and replace it with something that might work - a 12v travel kettle type thing that works from a car's electrics, f'rinstance?
Stew
Ignorance is essential
						Ignorance is essential
- 
				sparticuss
- margo - newbie 
- Posts: 22
- Joined: Wed Dec 14, 2005 1:56 am
Quite possibly is muddy . Nice and cheap too.Muddypause wrote:I think you might have your work cut out trying to make a 240v heating element do much with only 12v trying to push through it - I think the resistance will simply be too great.
Is it possible to get the element out and replace it with something that might work - a 12v travel kettle type thing that works from a car's electrics, f'rinstance?
I could use a hand though.
Do these oil filled heaters actually use a 240 volt element to heatthe oil in them.
And is there any problem using a heating element, which was designed to heat water, to heat something like oil.???????
Dont but ye boiler rushing mate. Winters six months off here.
 
 Today was 35degC and its still about 30.
- Muddypause
- A selfsufficientish Regular 
- Posts: 1905
- Joined: Mon Apr 11, 2005 4:45 pm
- Location: Urban Berkshire, UK (one day I'll find the escape route)
I would have thought they used a 240v element - can't really see the point of losing efficiency by stepping down the voltage. But I've not got first hand experience of them.
I guess whether the element would be suitable for heating oil depends upon what type of oil it is. Maybe if it has a low boiling point or something, it might not work. You can get electric deep fat fryers, so the elements must work in oil, but of course thay are intended to make it boil, which is not really what you are after. You may make any thermostat work hard to keep the temperature down.
			
			
									
									I guess whether the element would be suitable for heating oil depends upon what type of oil it is. Maybe if it has a low boiling point or something, it might not work. You can get electric deep fat fryers, so the elements must work in oil, but of course thay are intended to make it boil, which is not really what you are after. You may make any thermostat work hard to keep the temperature down.
Stew
Ignorance is essential
						Ignorance is essential
