Page 1 of 1


Posted: Sun Aug 29, 2010 6:26 pm
by dave45
I have been given a load of scrap pallets by the local builders yard and the kids have been having fun hitting them with crowbars to split them up... but some are connected with "gang-nails" or "connector plates" ( ... tor-plates describes them). Brute force can crack the joint apart but leave the plates embedded in each bit of the wood.

I know I can burn the wood with them attached, but it seems rather a lot of ironmongery... does anyone know how to detach them? some of the longer timbers are in good nick and look re-usable too if we could only get rid of the gang-nails

Re: gang-nails

Posted: Mon Aug 30, 2010 7:34 am
by frozenthunderbolt
get a pry bar underneath the plate and lever it out then use the timber carefully - dont ruin your saw. FWIW we call them knuckle plates over here :-)